# RUN: not llvm-mc -disassemble -triple=aarch64 %s 2> %t
# RUN: FileCheck %s < %t
# RUN: not llvm-mc -disassemble -triple=arm64 %s 2> %t
# RUN: FileCheck %s < %t

# Instructions notionally in the add/sub (extended register) sheet, but with
# invalid shift amount or "opt" field.
[0x00 0x10 0xa0 0x0b]
[0x00 0x10 0x60 0x0b]
[0x00 0x14 0x20 0x0b]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding

# Instructions notionally in the add/sub (immediate) sheet, but with
# invalid "shift" field.
[0xdf 0x3 0x80 0x91]
[0xed 0x8e 0xc4 0x31]
[0x62 0xfc 0xbf 0x11]
[0x3 0xff 0xff 0x91]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding

# Instructions notionally in the load/store (unsigned immediate) sheet.
# Only unallocated (int-register) variants are: opc=0b11, size=0b10, 0b11
[0xd7 0xfc 0xff 0xb9]
[0xd7 0xfc 0xcf 0xf9]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding

# Instructions notionally in the floating-point <-> fixed-point conversion
# Scale field is 64-<imm> and <imm> should be 1-32 for a 32-bit int register.
[0x23 0x01 0x18 0x1e]
[0x23 0x25 0x42 0x1e]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding

# Instructions notionally in the logical (shifted register) sheet, but with out
# of range shift: w-registers can only have 0-31.
[0x00 0x80 0x00 0x0a]
# CHECK: invalid instruction encoding

# Instructions notionally in the move wide (immediate) sheet, but with out
# of range shift: w-registers can only have 0 or 16.
[0x00 0x00 0xc0 0x12]
[0x12 0x34 0xe0 0x52]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding

# Data-processing instructions are undefined when S=1 and for the 0b0000111
# value in opcode:sf
[0x00 0x00 0xc0 0x5f]
[0x56 0x0c 0xc0 0x5a]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding

# Data-processing instructions (2 source) are undefined for a value of
#  0001xx:0:x or 0011xx:0:x for opcode:S:sf
[0x00 0x30 0xc1 0x1a]
[0x00 0x10 0xc1 0x1a]
# CHECK: invalid instruction encoding
# CHECK: invalid instruction encoding