// REQUIRES: x86-registered-target // REQUIRES: nvptx-registered-target // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_20 --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=OK // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_20 --cuda-path=%S/Inputs/CUDA_80/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=OK // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-path=%S/Inputs/CUDA_80/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=OK // Test version guess when cuda.h has not been found // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-path=%S/Inputs/CUDA-unknown/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=UNKNOWN_VERSION // Unknown version info present in cuda.h // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-path=%S/Inputs/CUDA-new/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=UNKNOWN_VERSION // Make sure that we don't warn about CUDA version during C++ compilation. // RUN: %clang --target=x86_64-linux -v -### -x c++ --cuda-gpu-arch=sm_60 \ // RUN: --cuda-path=%S/Inputs/CUDA-unknown/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=UNKNOWN_VERSION_CXX // The installation at Inputs/CUDA is CUDA 7.0, which doesn't support sm_60. // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=ERR_SM60 // This should only complain about sm_60, not sm_35. // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-gpu-arch=sm_35 \ // RUN: --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=ERR_SM60 --check-prefix=OK_SM35 // We should get two errors here, one for sm_60 and one for sm_61. // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-gpu-arch=sm_61 \ // RUN: --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=ERR_SM60 --check-prefix=ERR_SM61 // We should still get an error if we pass -nocudainc, because this compilation // would invoke ptxas, and we do a version check on that, too. // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 -nocudainc --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=ERR_SM60 // If with -nocudainc and -E, we don't touch the CUDA install, so we // shouldn't get an error. // RUN: %clang --target=x86_64-linux -v -### -E --cuda-device-only --cuda-gpu-arch=sm_60 -nocudainc \ // RUN: --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=OK // --no-cuda-version-check should suppress all of these errors. // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-path=%S/Inputs/CUDA/usr/local/cuda 2>&1 \ // RUN: --no-cuda-version-check %s | \ // RUN: FileCheck %s --check-prefix=OK // We need to make sure the version check is done only for the device toolchain, // therefore we should not get an error in host-only mode. We use the -S here // to avoid the error being produced in case by the assembler tool, which does // the same check. // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-host-only --cuda-path=%S/Inputs/CUDA/usr/local/cuda -S 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=OK // RUN: %clang --target=x86_64-linux -v -### --cuda-gpu-arch=sm_60 --cuda-device-only --cuda-path=%S/Inputs/CUDA/usr/local/cuda -S 2>&1 %s | \ // RUN: FileCheck %s --check-prefix=ERR_SM60 // OK-NOT: error: GPU arch // OK_SM35-NOT: error: GPU arch sm_35 // We should only get one error per architecture. // ERR_SM20: error: GPU arch sm_20 {{.*}} // ERR_SM20-NOT: error: GPU arch sm_20 // ERR_SM60: error: GPU arch sm_60 {{.*}} // ERR_SM60-NOT: error: GPU arch sm_60 // ERR_SM61: error: GPU arch sm_61 {{.*}} // ERR_SM61-NOT: error: GPU arch sm_61 // UNKNOWN_VERSION: CUDA version is newer than the latest{{.*}} supported version // UNKNOWN_VERSION_CXX-NOT: unknown CUDA version